EPDM Adhesive

EPDM Membrane Adhesive

High Tack, Polymer Based High Viscosity EPDM Adhesive With Low Solvent Content. 

Adheres EPDM & Butyl Membranes to Hard PVC, Aluminium, Steel, Galvanised Steel, Acrylic Glass, Concrete, Light Weight Concrete, Lead, Wood & Bitumen

This paste adhesive allows the position of the strip to be adjusted.

Application Instructions:

• Paste Adhesive 3300 is applied on substrate with standard type of hand or electric gun or putty spade.
• Apply the paste in 2-3 beads to the substrate.
• Wait a couple of minutes before fixing the membrane into the paste.
• Spread the paste or apply the EPDM membrane directly over the beads so that a 1 mm thick layer of adhesive is covering a width of approx 100 mm.
• Apply pressure using a silicone or steel roller.
• When adhering vertically the paste shall be applied and pressed until a 1 mm bead is visible outside the membrane edge, to seal the splice.
• Make sure that the strip is applied without building in tension and stress to the splice.
• Seams between strips must have a minimum overlap of 100 mm, bonded together with paste adhesive.
• The paste shall be applied and pressed until a 1 mm bead is visible outside the membrane edge, to seal the splice.
• Note: Paste adhesivemust not be applied in temperatures below 5°C.
• Warning: Paste Adhesive is flammable. Avoid open flames.
• Each 600ml Foil Produces 10 Meters of Bead (average use is 3 600ml foils per Roll)