EPDM Adhesive

£8.64 £7.20
Rating:
100 % of 100
In stock
SKU (Orderwise Code)
CLADSEALPASTE3300
  • Buy 48 for £8.21 £6.84 each and save 5%
SKU: CLADSEALPASTE3300
Manufacturer: Affixit

EPDM Membrane Adhesive

High Tack, Polymer Based High Viscosity EPDM Adhesive With Low Solvent Content. 

Adheres EPDM & Butyl Membranes to Hard PVC, Aluminium, Steel, Galvanised Steel, Acrylic Glass, Concrete, Light Weight Concrete, Lead, Wood & Bitumen

This paste adhesive allows the position of the strip to be adjusted.

Application Instructions:

  • Paste Adhesive 3300 is applied on substrate with standard type of hand or electric gun or putty spade.
  • Apply the paste in 2-3 beads to the substrate.
  • Wait a couple of minutes before fixing the membrane into the paste.
  • Spread the paste or apply the EPDM membrane directly over the beads so that a 1 mm thick layer of adhesive is covering a width of approx 100 mm.
  • Apply pressure using a silicone or steel roller.
  • When adhering vertically the paste shall be applied and pressed until a 1 mm bead is visible outside the membrane edge, to seal the splice.
  • Make sure that the strip is applied without building in tension and stress to the splice.
  • Seams between strips must have a minimum overlap of 100 mm, bonded together with paste adhesive.
  • The paste shall be applied and pressed until a 1 mm bead is visible outside the membrane edge, to seal the splice.
  • Note: Paste adhesivemust not be applied in temperatures below 5°C.
  • Warning: Paste Adhesive is flammable. Avoid open flames.

EPDM Membrane Adhesive

High Tack, Polymer Based High Viscosity EPDM Adhesive With Low Solvent Content. 

Adheres EPDM & Butyl Membranes to Hard PVC, Aluminium, Steel, Galvanised Steel, Acrylic Glass, Concrete, Light Weight Concrete, Lead, Wood & Bitumen

This paste adhesive allows the position of the strip to be adjusted.

Application Instructions:

  • Paste Adhesive 3300 is applied on substrate with standard type of hand or electric gun or putty spade.
  • Apply the paste in 2-3 beads to the substrate.
  • Wait a couple of minutes before fixing the membrane into the paste.
  • Spread the paste or apply the EPDM membrane directly over the beads so that a 1 mm thick layer of adhesive is covering a width of approx 100 mm.
  • Apply pressure using a silicone or steel roller.
  • When adhering vertically the paste shall be applied and pressed until a 1 mm bead is visible outside the membrane edge, to seal the splice.
  • Make sure that the strip is applied without building in tension and stress to the splice.
  • Seams between strips must have a minimum overlap of 100 mm, bonded together with paste adhesive.
  • The paste shall be applied and pressed until a 1 mm bead is visible outside the membrane edge, to seal the splice.
  • Note: Paste adhesivemust not be applied in temperatures below 5°C.
  • Warning: Paste Adhesive is flammable. Avoid open flames.
  • Each 600ml Foil Produces 10 Meters of Bead (average use is 3 600ml foils per Roll)
  • Free Delivery Over £49

    Next Working Day

    (order by 2pm)

    1 Hr Delivery Slot Issued on Morning of Delivery

  • ISO 9001 : 2015 Approved

    Quality Assured

     

    35 Years Experience.

Write Your Own Review

You're reviewing:

EPDM Adhesive


Your Rating