EPDM Adhesive
- Buy 48 for £8.21 £6.84 each and save 5%
EPDM Membrane Adhesive
High Tack, Polymer Based High Viscosity EPDM Adhesive With Low Solvent Content.
Adheres EPDM & Butyl Membranes to Hard PVC, Aluminium, Steel, Galvanised Steel, Acrylic Glass, Concrete, Light Weight Concrete, Lead, Wood & Bitumen
This paste adhesive allows the position of the strip to be adjusted.
Application Instructions:
- Paste Adhesive 3300 is applied on substrate with standard type of hand or electric gun or putty spade.
- Apply the paste in 2-3 beads to the substrate.
- Wait a couple of minutes before fixing the membrane into the paste.
- Spread the paste or apply the EPDM membrane directly over the beads so that a 1 mm thick layer of adhesive is covering a width of approx 100 mm.
- Apply pressure using a silicone or steel roller.
- When adhering vertically the paste shall be applied and pressed until a 1 mm bead is visible outside the membrane edge, to seal the splice.
- Make sure that the strip is applied without building in tension and stress to the splice.
- Seams between strips must have a minimum overlap of 100 mm, bonded together with paste adhesive.
- The paste shall be applied and pressed until a 1 mm bead is visible outside the membrane edge, to seal the splice.
- Note: Paste adhesivemust not be applied in temperatures below 5°C.
- Warning: Paste Adhesive is flammable. Avoid open flames.
EPDM Membrane Adhesive
High Tack, Polymer Based High Viscosity EPDM Adhesive With Low Solvent Content.
Adheres EPDM & Butyl Membranes to Hard PVC, Aluminium, Steel, Galvanised Steel, Acrylic Glass, Concrete, Light Weight Concrete, Lead, Wood & Bitumen
This paste adhesive allows the position of the strip to be adjusted.
Application Instructions:
- Paste Adhesive 3300 is applied on substrate with standard type of hand or electric gun or putty spade.
- Apply the paste in 2-3 beads to the substrate.
- Wait a couple of minutes before fixing the membrane into the paste.
- Spread the paste or apply the EPDM membrane directly over the beads so that a 1 mm thick layer of adhesive is covering a width of approx 100 mm.
- Apply pressure using a silicone or steel roller.
- When adhering vertically the paste shall be applied and pressed until a 1 mm bead is visible outside the membrane edge, to seal the splice.
- Make sure that the strip is applied without building in tension and stress to the splice.
- Seams between strips must have a minimum overlap of 100 mm, bonded together with paste adhesive.
- The paste shall be applied and pressed until a 1 mm bead is visible outside the membrane edge, to seal the splice.
- Note: Paste adhesivemust not be applied in temperatures below 5°C.
- Warning: Paste Adhesive is flammable. Avoid open flames.
- Each 600ml Foil Produces 10 Meters of Bead (average use is 3 600ml foils per Roll)
-
Free Delivery Over £49
Next Working Day
(order by 2pm)
1 Hr Delivery Slot Issued on Morning of Delivery
-
ISO 9001 : 2015 Approved
Quality Assured
35 Years Experience.